Pre Operation; Important; Plates Selection - Skymsen PA-141 Manual De Instrucciones

To adjust voltage use the Voltage Selector Switch to be found on the back
side of the processor Base.
Move the Switch to the desired voltage.
The power plug has 3 pins and the middle pin is the ground . It is
mandatory all the 3 pins must be properly connected .before to start
operation.

2.2 Pre Operation

Before to start operation make sure the
plate is correctly fixed , to avoid damages to the machine.
The processor shall be firm on its position.
Before firth operation wash with water and neutral soap all the parts
which are to be in contact with the products to be processed.
2.3 Plate Selection
The below Table 03 helps to select the correct Plate for the desired
operation.
Table 03
Cutting Selection Table
BEET SLICE
SHREDS
CARROTS SLICE
SHREDS
GRATERS
CABBAGE SLICE
SHREDS
MUSHROOMS SLICE
ONION SLICE
PEPPER SLICE
RADISH SLICE
SHREDS
LEAVES SLICE
POTATOES SLICE-CHIPS
STRAW
ORANGES SLICE
COCO NUTS SHREDS
GRATERS

IMPORTANT

1.5 and 3 mm slicer
3, 5, 8 mm shredder
1.5 and 3 mm slicer
3, 5, 8 mm shredder
GRATER
1.5 and 3 mm slicer
3, 5, 8 mm shredder
1.5 and 3 mm slicer
1.5 and 3 mm slicer
1.5 and 3 mm slicer
1.5 and 3 mm slicer
3, 5, 8 mm shredder
1.5 and 3 mm slicer
1.5 and 3 mm slicer
3, 5, 8 mm shredder
1.5 and 3 mm slicer
3, 5, 8 mm shredder
GRATER
05