Description; Use Of The Product As Directed - Hilti PMP 45 Manual De Instrucciones

Symbols
Read the Disposal of
operating power tools
instructions or
before use. appliances
and batteries
together with
household
waste is not
permissible.
Laser class 2
according to
EN 60825-
3:2007

2 Description

2.1 Use of the product as directed

The PMP 45 is a self-levelling point laser which allows a single person to level, plumb, align and transfer right angles
quickly and accurately. The tool features five coincident laser beams (beams that originate from the same point). All
beams have the same range of 30m (range depends on the brightness of ambient light).
The tool is designed for use mainly in interiors, for determining and checking vertical lines, alignment lines, and for
marking plumb points.
When used for outdoor applications, care must be taken to ensure that the general conditions are similar to those
encountered indoors. For example:
Marking the position of partition walls (at right angles and in the vertical plane).
Aligning components to be installed or sections of a structure in three axes.
Checking and transferring right angles.
Transferring measuring marks from the floor to the ceiling.
Modification of the tool is not permissible.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
2.2 Features
Highly accurate horizontal and vertical beams (±3 mm at 10 m).
Self-levelling to within ±5° in all directions.
Short self-levelling time: ~3 seconds
When the self-leveling range is exceeded, the laser beam blinks to warn the user.
The PMP 45 is characterized by its ease of operation and use, its rugged plastic casing and ease of transport due to
its compact dimensions and light weight.
When in normal operating mode, the tool switches itself off after 15 minutes. Sustained operating mode can be
selected by pressing the on/off button for four seconds.
Laser class II
according to
CFR 21, § 1040
(FDA)
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
en
11