Description; Use Of The Product As Directed; Description Of The Tool; Technical Data - Hilti POS 15 Manual De Instrucciones

Symbol for Laser Class II / Class 2
Laser class II
according to
CFR 21, § 1040
en
(FDA)
Symbol for Laser Class III / Class 3
Laser class II
according to
CFR 21, § 1040 (FDA)

2 Description

2.1 Use of the product as directed

The tool is designed for measuring distances and direc-
tions, calculating target positions in 3 dimensions and
the values derived from these positions and for laying
out points using given coordinates or values relative to a
control line.
To avoid the risk of injury, use only genuine Hilti ac-
cessories and insert tools.
Observe the information printed in the operating instruc-
tions concerning operation, care and maintenance.
Take the influences of the surrounding area into account.
Do not use the appliance where there is a risk of fire or
explosion.

3 Technical data

Right of technical changes reserved.
NOTE
The only difference between the two tools is their angle measurement accuracy.
Telescope
Telescope magnification
Shortest target distance
Telescope angle of view
Objective lens aperture
14
Laser Class
2 in
accordance
with IEC/EN
60825‑1:2007
3R
Do not look
into the
beam with
the naked
eye or with
optical
instruments.
Laser exit aperture
Laser exit aperture
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Generation: 01
Serial no.:
Modification of the tool is not permissible.

2.2 Description of the tool

The POS 15/18 total station can be used to determine the
exact position of objects or points. The tool is equipped
with horizontal and vertical circles with digital graduation,
two electronic levels (compensators), a coaxial laser dis-
tancer incorporated in the telescope and an electronic
processor system for calculating and saving data.
Hilti PROFIS Layout, a PC application from Hilti, can be
used to transfer data in both directions between the total
station and a PC, for data processing and for exporting
data to other systems.
30x
1.5 m (4.9 ft)
1° 20': 2.3 m / 100 m (7.0 ft / 300 ft)
45 mm (1.8")