General Information; Safety Notices And Their Meaning; Description; Use Of The Product As Directed - Hilti PRI 36 Manual De Instrucciones

1 General information

1.1 Safety notices and their meaning

DANGER
Draws attention to imminent danger that will lead to
serious bodily injury or fatality.
WARNING
en
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
CAUTION
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
equipment or other property.
NOTE
Draws attention to an instruction or other useful informa-
tion.
1.2 Explanation of the pictograms and other
information
Symbols
Read the General
operating warning
instructions
before use.
For indoor Return
use only materials for
recycling

2 Description

2.1 Use of the product as directed

The tool is designed to be used to determine, transfer and check levels, verticals, slopes and right angles. Examples of
its uses are: transferring datums and height marks, determining right angles for walls, vertical alignment on reference
points and setting out slopes.
The tool is designed for professional use and may be operated, serviced and maintained only by trained, authorized
personnel. This personnel must be informed of any special hazards that may be encountered. The tool and its ancillary
equipment may present hazards when used incorrectly by untrained personnel or when used not as directed.
Use of tools or AC adapters which show visible signs of damage is not permissible. Operation outdoors or in damp
conditions in "Charging during operation mode" is not permissible.
18
All manuals and user guides at all-guides.com
Warning: Warning:
caustic electricity
substances
3R
Laser Do not look
radiation into the
beam.
Avoid
exposing the
eyes to
direct
radiation.
Laser Class
3R
according to
EN 60825‑1:2007.
On the tool
Laser wave length 532nm, modulation frequency 1MHz,
pulse cycle 50%, focussed laser beam diameter at
pentaprism 5mm, speed of rotation 300 /min. Average
output power under the above conditions is <4.5 mW.
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.