Clatronic BS 1255 Instrucciones De Servicio página 32

Position in Use
• Place your foot on the
unlocking button (1) to
move the handle into
the required position.
• Switch the device on
with the on/off switch
(10).
Instructions for Use
NOTE:
Now you should vacuum at an even speed. Pressing
hard is not necessary.
CAUTION:
Pay attention to the restricted range due to the length
of the cable!
Avoid damaging the surface being cleaned:
• Do not set the brushes too low!
• Do not allow the machine to remain stationary when
switched on!
Switching off
• Move the handle to a vertical position.
• Switch the device off using the on/off switch.
• Remove the plug connector from the plug socket.
• Use the cable take-up to stow away the cable.
Filter
Your machine has three fi lter systems.
1. Transparent dust collection container
The traditional dust bag system has been replaced by
a transparent dust collection container in which coarse
dirt particles and tiny particles floating in the air are
swirled out of the suction air by the high speed of the
air current.
The quantity of dust can be easily read off at any time
on the container, which is also very easy to empty.
The purchase of dust bags is no longer necessary.
2. Main Filter, Pre-fi lter (in the Dust Container)
WARNING:
Before removing and cleaning the fi lters switch the
device off and remove the plug from the socket.
Once the dust level has reached the MAX mark of the
dust container, please proceed as follows:
1. Press the button (3).
2. Remove the dust container.
3. Empty the contents of the dust container into a
suitable receptacle by pressing button on the dust
container (See illustration a).
32
05-BS 1255 32
NOTE:
Every third time that the fi lters are emptied, or
in the case of severe soiling, clean the fi lters
by allowing water to fl ow through them against
the direction in which the air blows. The fi lters
should only be re-inserted when they are com-
pletely dry!
4. To do so, release the lid with the main fi lter (b).
NOTE:
By means of short turns in a clockwise or
anticlockwise direction the following compon-
ents can be removed or separated.
5. Remove the main fi lter (c). This fi lter can also be
cleaned from time to time with the brush.
6. Remove the pre-fi lter (d). These components can
be separated once more (e).
7. When the components have been cleaned
and dried they can be reinstalled. Connect the
components again by short turns in a clockwise or
anticlockwise direction.
3. Motor Protection Filter
Clean the fi lter felt on the bottom of the dust housing
every time you empty the vacuum.
NOTE:
Every third time that the fi lters are emptied, or in the
case of severe soiling, clean the fi lters by allowing
water to fl ow through them against the direction in
which the air blows. The fi lters should only be re-
inserted when they are completely dry!
Outlet fi lter
We recommend that this fi lter should be cleaned every
fi fth time the vacuum cleaner is emptied.
This fi lter is located behind the ventilation grille (4) of the
front cover. Pull the fi lter out. Clean the fi lter as described
above.
07.02.2006, 14:35:33 Uhr