1
DESCRIPTION
1.1
PURPOSE
This machine is used to cut grass, light weeds, and
other similar vegetation at or around ground level. The
cutting plane must be approximately parallel to the
ground surface. You cannot use the machine to cut or
chop hedges, shrubs, bushes, flowers and compost.
1.2
PRODUCT OVERVIEW
Figure 1-18 .
Battery compartment
1
Rear handle
2
Lock-out button
3
Speed button
4
On/off button
5
Trigger
6
Lock latch
7
Auxiliary handle
8
Upper shaft
9
Coupler
10
Lower shaft
11
Guard
12
Blade
13
Trimmer head
14
Cut-off blade
15
Guard cap
16
Release button
17
Positioning hole
18
Knob
19
Lower clamp
20
Battery release button
21
Cut-off blade
22
Spool cover
23
Spool
24
Bump knob
25
Hole
26
Slot
27
Guide slot
28
Metal rod
29
Spacer
30
Inner cup
31
Blade
32
Outer ring-nut
33
Outer cup
34
Nut
35
Direction of roatation
A
Best cutting area
B
Dangerous cutting area
C
English
2
SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3
INSTALLATION
Remove the battery pack from the machine before
installation.
Do not use accessories that are not recommended for
this machine.
3.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
•
If the parts have damage, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2
ATTACH THE GUARD
Figure 2.
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a
Phillips screwdriver (not provided).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw
holes on the trimmer head.
4. Tighten the screws.
5. Put the guard cap onto the guard.
5
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
EN