Description; Purpose; Overview; Safety - GreenWorks GST1246 Manual Del Operario

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is used to cut grass, light weeds, and other
similar vegetation at or around ground level. The cutting
plane must be approximately parallel to the ground surface.
You cannot use the machine to cut or chop hedges, shrubs,
bushes, flowers and compost.
1.2

OVERVIEW

Figure 1 - 18.
Plug
1
Lock-out button
2
Trigger
3
Auxiliary handle
4
Upper shaft
5
Knob
6
Lower shaft
7
Cap
8
Blade
9
Cut-off blade
10
Guard
11
Trimmer head
12
Lower clamp
13
Spool cover
14
Spool
15
Tab
16
Hole
17
Metal rod
18
Inner cup
19
Plate
20
Outer cup
21
Nut
22
Direction of rotation
A
Best cutting area
B
Dangerous cutting area
C
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

WARNING
English
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2

ATTACH THE GUARD

Figure 2.
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
screwdriver (not provided).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
5. Put the guard cap onto the guard.
6. Align the screw holes on the guard cap with the screw
holes on the guard.
7. Tighten the screws.
3.3

ASSEMBLE THE SHAFT

Figure 4.
1. Loosen the knob on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole and
move the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the knob.
3.4 ATTACH THE AUXILIARY
HANDLE
Figure 5.
4
WARNING
WARNING
WARNING