Oven Vent; Selecting The Oven Mode - Siemens xTronic HG2415UC Manual De Uso Y Cuidado

Setting the Cooking Mode
1. Touch COOKING MODE.
2. BAKE will flash in the display.
If no further setting is made within 5 seconds,
control will beep and flash. If this occurs, press
START.
3. To change the cooking mode, turn knob.
4. Push START.
The selected mode will appear in the display, along
with the default temperature for that mode, which
will be blinking.
5. To select a different temperature, turn knob to
desired temperature.
6. Touch START. If START is not touched, oven will
automatically turn on in 5 seconds.
7. The display alternates between the cooking mode
and preheat.
The preheated temperature is also displayed, starting
at 100ºF. The actual temperature increases until set
temperature is reached, at which point the oven
will beep.
8. To change temperature during cooking, touch
TEMPERATURE. Turn the knob to select new
Temperature and press START.
9. Once cooking has been completed, touch OFF to
turn off oven.
Note: After the oven has been turned off, HOT appears
in the display where the cooking mode was. This is to
indicate that the oven is off but still hot. When the oven
temperature drops below 176° F, HOT is no longer seen
in the display.
Oven Operation Time
The oven will automatically shut off after 12 hours (24
hours if the time format is set for 24 hour in the SELECT
FUNCTION section).

Oven Vent

The oven vent is located above the cooktop directly
below the display.
Caution:
This area may become hot
when the oven is in use
It is normal to see steam escaping from the vent and
condensation may collect on the backguard and cooktop.
This area may become hot when the oven is in use.
Do not block the vent as it is important for air circulation.

Selecting the Oven Mode

6: 35 6: 35 6: 35 6: 35 6: 35
380º 380º 380º
380º 380º
PM
1 1 1 1 1 00 00 00 00 00 B B B B B AKE AKE AKE
AKE AKE
HELPFUL TIP
To back out of a current
mode, push OFF.
Selecting OFF when not
in a setting mode will
stop oven function.