Tabla De Contenido; Let's Get Started - Schlage CONNECT Guia De Instalacion

LET'S GET STARTED!

Once you have all your tools together, please follow each step carefully and in order. Because
this is an electronic lock, the order of steps is very important. If you skip a step, you may have
to perform a factory default reset and start over.
You will definitely need this tool:
• Phillips screwdriver
You can use a manual or electric
screwdriver, but please DO NOT use a
power drill!
INSTALLATION NOTES! PLEASE READ!
• DO NOT use a power drill for installation! This could damage the lock.
• Please read all the instructions before calling customer support.
• Please call customer support before returning the product to the store.
• DO NOT install the batteries before installing the lock! Follow the instructions in order!
• If you have previously installed this lock on another door, you MUST perform a
Factory Default Reset FIRST! See the User's Guide for more information.
• This lock is designed for the following operating temperatures:
• Outside Lock Body (exterior mounted): -31˚F (-35˚C) to 151˚F (66˚C)
• Inside Lock Body (interior mounted): 14˚F (-10˚C) to 120˚F (49˚C)
STEPS AT A GLANCE
1 Check current door/frame alignment. ....................................................................................4
2 Remove the current deadbolt from the door. ........................................................................4
3 Watch the online video. ...........................................................................................................4
4 Check door/frame dimensions. ..............................................................................................5
5 Locate programming and User Codes. ..................................................................................5
6 Install bolt and strike. ..............................................................................................................6
6a Adjust bolt length, if necessary. ..........................................................................................6
6b Change the faceplate, if necessary. ...................................................................................6
6c Install the bolt into the door. ................................................................................................7
6d Install the strike into the frame. ...........................................................................................7
6e Test bolt alignment. .............................................................................................................8
7 Install the Touchscreen Assembly..........................................................................................8
7a Install the Touchscreen on the outside of the door. ............................................................8
7b Install the Support Plate on the inside of the door. .............................................................9
8 Install the Alarm Assembly. .....................................................................................................9
8a Remove the battery cover from the Alarm Assembly. .........................................................9
8b Connect the cable to the Alarm Assembly. .......................................................................10
8c Install the Alarm Assembly. ...............................................................................................10
8d Secure the Alarm Assembly to the Support Plate. ............................................................11
9 Install the Batteries. ...............................................................................................................11
9a Install the batteries into the battery tray. ...........................................................................11
9b Install the battery cover. ....................................................................................................12
10 Set up the Lock. .....................................................................................................................12
11 Test the Lock. .........................................................................................................................12
11a Extend the bolt (lock) using the inside thumbturn. ............................................................12
11b Extend the bolt (lock) using the Touchscreen. ..................................................................13
11c Retract the bolt (unlock) using the Touchscreen. .............................................................13
11d If the lock failed to lock or unlock: .....................................................................................13
12 Continue to the User's Guide. ..............................................................................................14
You may also need these tools:
• Tape Measure
• Flathead Screwdriver
• Pencil
• Wood Block
• Hammer
3