Kreg Jig HD Guia De Inicio Rapido página 6

Pocket-Hole Placement
® HD Drill Bit stop collar
setting, another important part of getting the
strongest possible Kreg Joint is spacing your pocket-
™
holes evenly across the workpiece. Your Kreg Jig
features a 2-hole Drill Guide which lets you do this in
3 ½"-wide stock (2x4s) without the need to reposition
the workpiece after each hole is drilled. Use the
guide below to determine how to best position your
workpiece when drilling pocket-holes.
2x6s
1" 1"
5 ½"-wide material (2x6s)
Center the fi rst guide 1" from one edge,
drill one pocket-hole, reposition the drill
guide with the second guide 1" from the
other edge, drill a second pocket-hole.
800-447-8638
2x4s
® HD
1" 1"
3 ½"-wide material (2x4s)
Center the jig on the 2x4 and drill
pocket-holes using both guides
without repositioning the workpiece.
2x8s
1" 2-5/8"
7 ¼"-wide (2x8s) and wider material
Drill pocket-holes 1" from each edge. Then
position the Drill Guide to drill pocket-holes
evenly spaced approximately 3" on center
between these holes.
Follow these fi ve simple steps for getting the most out of your Kreg Jig
and Kreg Jig
®
When working with 2x4s, simply center the Kreg Jig
1
workpiece, clamp it in place, and use both bit guides to drill your pocket-holes. For
2x6s and wider material, mark pocket-hole centerlines far enough from the end of
the board to clear the end of the Drill Guide (about 6"). To drill these pocket-holes,
you'll align one bit guide on the Kreg Jig
pocket-hole, and reposition the jig to drill the next pocket-hole.
With the Stop Block against the end of the board, position the Kreg Jig
2
board, and securely clamp the Kreg Jig
Before turning on the drill, insert the bit into the Drill Guide until the tip of the bit
3
touches the workpiece. Withdraw the bit about ¼".
Turn on the drill and feed the bit into the workpiece, "pumping" the bit as necessary
4
to clear the chips.
Stop drilling when the Stop Collar contacts the Drill Guide. Wait until the drill stops
5
1"
rotating to withdraw the bit.
Drilling Pocket-holes
HD Drill bit:
®
® HD with a marked centerline, drill the
HD in place.
® ®
® HD
HD on the width of the
HD on the
® ®
www.kregtool.com