Internal Connections; Description Of Controls; External Connections; Connecting The Wire Feeder - Cebora EVO SYNERGIC Manual De Instrucciones

3.2

INTERNAL CONNECTIONS

• Any intervention carried out inside the welding
machine must be performed by qualified personnel.
• Before working inside the welding machine, make sure
that the plug is disconnected from the power mains.
• After final inspection, the welding machine is
connected to the voltage indicated on the power
supply cable.
• To change the supply voltage, remove the right side
panel and arrange the voltage change terminal board
connections as shown in the figure 5.
• The supply voltage may not be changed on single-
phase power sources.
• Do not use the welding machine without its cover or
side panels for obvious safety reasons, and to avoid
altering the cooling conditions for internal components.

3.3 EXTERNAL CONNECTIONS

3.3.1 Connecting the mass clip.
• Connect the earth cable terminal to the socket V of the
welding machine, and connect the earth clamp to the
workpiece.
3.3.2 Cylinder placement and connecting the gas hose
• Position the cylinder on the cylinder holder of the
welding machine, using the straps provided to fasten it to
the rear panel of the machine.
• Periodically check for wear on the straps, and order
replacements if necessary.
• The cylinder must be equipped with a pressure regulator
complete with flow gauge.
• Only after positioning the cylinder, connect the outgoing
gas hose from the rear panel of the machine to the
pressure regulator.
• Adjust the gas flow to approximately 10/18 liters/minute.

3.3.3 Connecting the wire feeder

This power source accepts the wire feeders Art.1652 and Art.
1662. To connect the power source and wire feeder, use the
extension Art. 1182 (5 m) or Art. 1182.20 (10 m).
The performance and operating options of the wire feeder are
described in the instructions enclosed with the wire feeder itself.
Fig. 5

4 DESCRIPTION OF CONTROLS

4.1 CONTROLS ON THE FRONTOF THE MACHINE.
C
A
1 A - Selector switch
8 2
Fine-tunes the welding voltage within
the range previously selected via
7 3
selector switch S.
6 4
5
B- Selector switch
2 3
Select the ranges of welding voltage.
1 4
0
C - Switch
Turns the machine on or off.
1
V
Fig. 6
B
D
11