For Your Safety; Intended Use - Bosch GBM 10 Instrucciones De Servicio

For Your Safety

Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the enclosed booklet
must be observed.
Wear safety goggles.
For long hair, wear hair protection. Work only
with closely fitting clothes.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
Insert the mains plug only when the machine is
switched off.
Always direct the cable to the rear away from
the machine.
Hold the power tool only by the insulated
gripping surfaces, when performing an op-
eration where the cutting tool may run into
hidden wiring or its own cord.
Contact with a "live" wire will make exposed
metal parts of the tool "live" and shock the op-
erator.
Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assist-
ance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes
property damage or may cause an electric
shock.
If the drilling tool jams, it will cause the power
tool to jolt. If this occurs switch the machine off
immediately.
GBM 13-2/GBM 13-2 RE: Operate the ma-
chine only with the auxiliary handle 11.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
13 • 2 609 932 285 • TMS • 31.01.03
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Be careful when screwing in long screws; dan-
ger of sliding off.
When screwdriving, operate in first gear as
well as with a low speed.
Set the machine against the screw/nut only
when switched off.
Always switch the machine off and wait until it
has come to a standstill before placing it down.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.

Intended Use

The machine is intended drilling in wood, metal,
ceramic and plastic. Machines with electronic
control and right/left rotation are also suitable for
screwing and thread cutting.
Auxiliary Handle/Depth Stop
(see figure
The auxiliary handle can be mounted on the left
or right side of the spindle collar, using the
winged screw 9.
The drilling depth can be set with the depth
stop 10.
For this, loosen wing bolt for depth stop adjust-
ment 8, set the required drilling depth X and
tighten the wing bolt again.
The ribbing on depth stop 10 must point upwards.
English - 2
)
A