Disassembling The Blender; Preparing The Filter For Use; Using The Filter - Philips HR2002 Manual Del Usario

Turn the control knob to the pulse setting if you want to process ingredients very briefly.
tips
If you want to crush ice cubes, put not more than 6 ice cubes (of approx. 25x35x25mm) in the
-
blender jar and turn the control knob to pulse position a few times.
- Cut meat or other solid ingredients into smaller pieces before putting them in the blender jar.
- Do not process a large quantity of solid ingredients at the same time. To get good results, we
advise you to process these ingredients in a series of small batches.
- To make tomato juice, cut the tomatoes in four and drop the pieces through the opening in the
lid onto the rotating blades.

Disassembling the blender

1 Remove the mains plug from the wall socket.
2 Remove the lid with the measuring cup from the blender jar.
3 Turn the blender jar with the blade unit attached to remove it from the motor unit.
4 Clean all removable parts immediately after use (see chapter 'Cleaning').
Filter (HR2004 only)
With the filter you can make delicious fresh fruit juices, cocktails or soy milk. The filter prevents pips
and skins from ending up in your drink.
You can order the filter for the HR2000 as an extra accessory from your Philips dealer.
Never overload the filter. Do not put more than 70g of soy beans (unsoaked weight) or 150g of
fruit in the filter at the same time.

preparing the filter for use

Mount the blender jar with the blade unit attached on the motor unit and fix it by turning it
1
clockwise ('click') (Fig. 4).
The blender jar can be mounted in two positions: with the handle on the right side or on the left
side.
Put the filter in the blender jar (Fig. 6).
2
Make sure that the grooves of the filter fit exactly onto the ribs inside the blender jar.
3 Put the mains plug in the wall socket.

using the filter

1 Place the lid on the blender jar.
Put the ingredients in the filter. (Fig. 7)
2
Do not exceed the MAX indication on the sieve mesh.
3 Pour water or another liquid (milk, juice, etc.) into the blender jar.
4 Insert the measuring cup into the hole in the lid.
Let the appliance run for approx. 40 seconds.
5
6 Switch off the appliance and remove the blender jar with the blade unit attached from the
motor unit.
Do not open/remove the lid. Leave the measuring cup and the filter in the jar.
7 Pour out the drink through the pouring lip of the blender jar. (Fig. 8)
EnglisH
9