Emptying The Filter; Maintenance&Storage - Bestway 58487 Manual Del Propietário

Emptying the filter

Locking position
Fig.1
1. Press side tabs simultaneously and remove the suction nozzle from the tube collar. (Fig.1)
2. Grasp the plastic area at the base of the filter cage (DO NOT GRASP THE FILTER CAGE SCREEN). Pull to remove it
from the suction nozzle. (Fig.2) Rinse the filter cage with water to remove any debris caught inside. If brushing is
deemed necessary, use only a soft brush to clean it gently and carefully.
3. Install the filter cage back to suction nozzle. Reverse the steps in point 2 to re-install the filter cage to the suction
nozzle. Make sure to align the raised notches on the inside of the filter cage opening to the notches under the suction
head at first.
4. Insert the suction nozzle (installed with filter cage) into the tube collar until it is in a locking position. You will hear a
"click" sound.
WARNING: Power off the electric vacuum by turning the switching knob anticlockwise
until it stops.
Maintenance&Storage
1.Battery discharges on its own during storage. The battery should be stored at room
temperature, charged to about 30% to 50% of its capacity.
2.You must recharge the battery at least once every three months if it is not frequently used.
• Disconnect all USB charging peripherals.
• Detach all accessories from the electric vacuum. If necessary, rinse the electric vacuum
and accessories with fresh water. DO NOT use detergent.
• Be sure to drain the water from the electric vacuum before storing it.
• Use a damp cloth to clean and dry the electric vacuum and its accessories.
• Store them in a well-ventilated area away from the sunlight, children, heat, ignition
sources, and pool chemicals. Ambient temperature for storage should be 10˚C – 25˚C
(50˚F – 77˚F). NOTE: A higher temperature may reduce the battery life during storage.
How to remove the battery pack
Recommended tools (not included):
Philips screwdriver and small slot screwdriver
1. Use the screwdriver to unfasten the 2
side screws to release the front portion
and then detach it from the main body.
2. Unfasten the 4 screws as shown and
then remove the front chamber to
expose the enclosure inside.
303021185357/21.0x28.5cm/58487/ SPA可充电清洁器欧规说明书/JS-YF-2017-B-04848-英
Releasing position
4
Fig.2