Technical Data; Noise And Vibration Information - MIRKA DEOS 383X Instrucciones De Manejo

en
• Reorient or relocate the receiving antenna .
• Increase the separation between the equipment and receiver .
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected .
• Consult the dealer or an experienced radio/TV technician for help .
CAUTION TO THE USER: Changes or modification not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment . This device complies with Industry Canada's licence-exempt
RSSs . Operation is subject to the following two conditions:
1 . This device may not cause interference; and
2 . This device must accept any interference, including interference that may cause undesired operation of the device .

Technical data

Mirka® DEOS
Power
Mains voltage
Speed
Orbit
Size of backing pad
Weight
Degree of protection

Noise and vibration information

Measured values are determined according to EN 60745 .
Mirka® DEOS
Sound pressure level (L
Sound power level (L
Sound measurement uncertainty K
Vibration emission value a
Vibration emission uncertainty K *
Specifications subject to change without prior notice . Model range may vary between markets .
* The values stated in the table are derived from laboratory testing in conformity with stated codes and standards and
are not sufficient for risk evaluation . Values measured in a particular work place may be higher than the declared
values . The actual exposure values and amount of risk or harm experienced by an individual are unique to each
situation and depend upon the surrounding environment, the way in which the individual works, the particular
material being worked, work station design and the user's exposure time and physical condition . Mirka Ltd accepts
no responsibility for the consequences of using declared values instead of actual exposure values for any individual
risk assessment .
Further occupational health and safety information can be obtained from the following websites:
https://osha .europa .eu/en (Europe) or http://www .osha .gov (USA)
Proper use of tool
This sander is designed for sanding all types of materials, i .e . metals, wood, stone, plastics, etc . using abrasives designed
for this purpose . Do not use this sander for any other purpose than that specified without consulting the manufacturer
or the manufacturer's authorized supplier . Only use original Mirka backing pads that are designed for optimal
performance . Other backing pads may reduce performance and will increase vibration . The cooling air vents on the
housing must be kept clean and free of blockages to ensure air circulation . Any maintenance or repair work may only
be carried out by an authorized service center .
10
Mirka® DEOS • 81 x 133 mm (3" x 5") & 70 x 198 mm (3" x 8")
)
pA
)
WA
*
h
383X CV
250 W
100–120 VAC
5,000–10,000 rpm
3 .0 mm (1/8")
70 x 198 mm (2-3/4" x 7-3/4")
1 .0 kg (2 .2 lbs)
I
383X CV
71 dB(A)
82 dB(A)
3 .0 dB
2 .6 m/s
2
1 .5 m/s 2
353X CV
250 W
100–120 VAC
5,000–10,000 rpm
3 .0 mm (1/8")
81 x 133 mm (3-1/8" x 5-1/4")
0 .97 kg (2 .1 lbs)
I
353X CV
69 dB(A)
80 dB(A)
3 .0 dB
2 .6 m/s
2
1 .5 m/s 2