Loading Nails - Hitachi NR65AK Manual De Instrucciones

Adjust the air pressure at recommended operating
pressure 80 – 120 psi (5.4 – 8.3 bar 5.5 – 8.5 kgf/cm
according to the length of nails and the hardness of
workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.

LOADING NAILS

WARNING
When loading nails into Nailer,
1) do not depress trigger;
2) do not depress push lever; and
3) keep your face, hands feet and other body
parts, as well as those of other persons away
from the nose muzzle to avoid possible injury
during usage and carrying.
Do not insert different length sized nail strips at
same time. If do so, it could result in damaging
nail strips and jamming.
Always point first nail protruded from the nose
away yourself and others.
Keep your face, hands, feet, other body parts as
well as those of other person away from the nose
muzzle to avoid possible injury during usage and
carrying.
Nail point
(1) Adjust the proper position of the nail gate of the
magazine end for the nail length.
There are 2-positions, lower position for 1-1/2" (38mm)
length and upper position for 2-1/2" (64mm) length.
Nail Gate
When nails are loaded in the magazine, the nail gate
can not be changed to the other position.
(2) Insert nail strips from rear of magazine.
2 )
(3) Slide the nail strip forward in the magazine.
The nail strip should pass over the nail stopper, which
means it is in proper position.
(4) Pull the nail feeder back with depressing the feeder
plate knob to push the nail strip.
Feeder Plate Knob
NOTE:
Use nail strip of more than 5 nails.
The Nailer is now ready to operate.
Removing the nails:
1 Depress the feeder plate knob slightly and slowly
slide the nail feeder forward.
2 Remove the nails from the Nailer.
— 13 —
Nail Stopper
Nail Strip
Feeder Plate
Knob
English
Nail
Feeder