Water And Ice Dispensers - Sears Kenmore ELITE 10654789801 Manual De Uso Y Cuidado

Refrigerator Controls
When adjust mode is activated, the fourth and fifth buttons (from
the left) adjust the refrigerator compartment temperature. The set
point range for the refrigerator is 33°F to 45°F (0°C to 7°C).
• Press the fourth button (down arrow) to lower the set point.
• Press the fifth button (up arrow) to raise the set point.
Freezer Controls
When adjust mode is activated, the second and third buttons
(from the left) adjust the freezer compartment temperature. The
set point range for the freezer is -5°F to 5°F (-21°C to -15°C).
• Press the second button (down arrow) to lower the set point.
• Press the third button (up arrow) to raise the set point.
CONDITION: TEMPERATURE
ADJUSTMENT:
REFRIGERATOR too cold REFRIGERATOR Setting
1° higher
REFRIGERATOR too warm REFRIGERATOR Setting
1° lower
FREEZER too cold FREEZER Setting
1° higher
FREEZER too warm/too little ice FREEZER Setting
1o lower
Press RETURN to exit adjust mode, or allow about 15 seconds of
inactivity and adjust mode will turn off automatically.
Additional Features
Accelerated Ice Production
The Accelerated Ice feature assists with temporary periods of
heavy ice usage by increasing ice production over a 24-hour
period.
• Press the ACCELER ICE button to turn on the feature. The
display screen indicates whether the feature is on or off.
ON OFF
The Accelerated Ice setting will remain on for 24 hours unless
manually turned off. The display will continue to show your
normal temperature set point.
NOTE: If increased ice production is desired at all times, change
the freezer control to a lower setting. Setting the freezer to a
colder temperature may make some foods, such as ice cream,
harder.
SmartSense
TM
Temperature Management
The SmartSense
TM
feature assists with regulating the
temperature inside the refrigerator and freezer. If a large quantity
of warm food is placed in the refrigerator or warm air enters the
refrigerator while the door is held open, SmartSense
TM
activates
to quickly restore the temperature to the set point.
smartsense
NOTE: SmartSense
TM
is always on when your refrigerator is
operating. You do not need to press any buttons to activate it.
The SmartSense
TM
icon on the dispenser display screen
indicates that the feature is functioning properly.
Temperature Display Always On
This feature keeps the temperature display on at all times.
• Press and hold TEMP and LOCK at the same time for
3 seconds to turn the feature on.
IMPORTANT: To avoid unintentionally locking the dispenser
or changing other settings, be sure to press both buttons at
exactly the same time.
• Press and hold TEMP and LOCK at the same time for
3 seconds again to turn the feature off.
Door Ajar Alarm
The Door Ajar Alarm feature sounds an alarm when the
refrigerator or freezer door is open for 5 minutes and the product
cooling is turned on. The alarm will repeat every 2 minutes. Close
both doors to turn it off. The feature then resets and will
reactivate when either door is left open again for 5 minutes.
Disabling Sounds
• To turn off all dispenser and control sounds, including the
Door Ajar Alarm, press and hold TEMP and UNITS at the
same time for 3 seconds.
IMPORTANT: To avoid unintentionally changing other
settings, be sure to press both buttons at exactly the same
time.
• To turn all sounds back on, press and hold TEMP and UNITS
at the same time for 3 seconds again.
Depending on your model, you may have one or more of the
following options: the ability to select shaved, crushed or cubed
icel a special light that turns on when you use the dispenser; or a
lock option to avoid unintentional dispensing.
NOTES:
• The dispensing system will not operate when the freezer door
is open.
• After connecting the refrigerator to a water source, flush the
water system. Use a sturdy container to depress and hold the
water dispenser pad for 5 seconds, then release it for
5 seconds. Repeat until water begins to flow. Once water
begins to flow, continue depressing and releasing the
dispenser pad (5 seconds on, 5 seconds off) for an additional
5 minutes. This will flush air from the filter and water
dispensing system. Additional flushing may be required in
some households. As air is cleared from the system, water
may spurt out of the dispenser.
• Allow 24 hours for the refrigerator to cool down and chill
water.
Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced.
The display screen on the dispenser control panel has a
backlight, which will turn off automatically when the control
buttons have not been used for 30 seconds or more. When
the backlight is off, the first press of a control button will only
reactivate the backlight, without changing any settings.
Within 30 seconds after the backlight has been reactivated,
additional presses of control buttons will change the
applicable settings.
12