Hitachi DN 12DY Manual De Instrucciones página 16

English
Recharge the batteries before they become completely exhausted.
When you feel that the power of the tool becomes weaker, stop using the tool and
recharge its battery. If you continue to use the tool and exhaust the electric current,
the battery may be damaged and its life will become shorter.
Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after use. If such a battery is
recharged immediately after use, its internal chemical substance will deteriorate,
and the battery life will be shortened. Leave the battery and recharge it after it has
cooled for a while.
CAUTION:
When the battery charger has been continuously used, the battery charger will be
heated, thus constituting the cause of the failures. Once the charging has been
completed, give 15 minutes rest until the next charging.
If the battery is recharged when it is warm due to battery use or exposure to sunlight,
the pilot lamp may not light.
The battery will not be recharged. In such a case, let the battery cool before charging.
<UC14YF2/UC14YFA/UC24YFA>
Rechargeable battery
Hole for
connecting the
rechargeable
battery
Pilot lamp
UC14YF2
Rechargeable battery
Pilot lamp
UC14YFA, UC24YFA
Fig. 5
16
1. Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been
inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as
shown in Fig. 5. Make sure it contacts the
bottom of the battery charger.
CAUTION:
If the batteries are inserted the wrong way,
not only won't they recharge, but they may
damage the charger by blowing the fuse or
deforming the terminals.
Hole for
connecting the
rechargeable
battery
WARNING:
Do not use the electrical cord
if damaged. Have it repaired
immediately.