Installation Testing - Kulzer cara Scan 4.0 Guia De Inicio Rapido

cara Scan 4.0 Quick Start Guide
12
After a few seconds, the projector should light up the rotary table with a cara Scan 4.0
warm up sequence:
When the warm up sequence is finished the scanner will be in idle mode ready for the
operations. The PC monitor will show the standard Windows desktop page.
On the left side there are the two icons belonging to cara software application:
cara Scan and cara CAD. See cara Scan or cara CAD User's Guide for more details about
them.
7.1.1

Installation Testing

NOTE
·
Installation testing is required only the first time the scanner is extracted from the
package or moved to another location. During the day by day operations this activity is
not required.
To check if the scanner is working properly, two mandatory steps have to be
performed:
1. Perform a Reset Axes.
2. Acquire a model in Basic Mode.
W19641_REF_66069511_13_QSG_02GB_caraScan4.0_V02
© 2018 Kulzer GmbH