Charge Status Display; Items Supplied - Hilti SID 14­A Manual De Instrucciones

▶ To power the impact screwdriver/wrench, use a rechargeable battery of a type approved by Hilti and a
charger from the C4/36 series.
Note
Make sure that the outer surfaces of the battery are clean and dry before inserting the battery in
an approved battery charger.
Read the operating instructions for the charger for further information about the charging procedure.
If the power tool is used for applications that require a specific torque, or where a certain maximum torque
must not be exceeded, there is a risk of over-tightening and damage to the screw or workpiece.
▶ Do not use the power tool for applications that require a precise or specified torque. Instead, use a tool
that allows the torque to be set as required.

3.3 Charge status display

The charge status of the Li­ion battery is displayed after pressing one of the release buttons lightly (press
only until slight resistance is felt).
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
Note
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.

3.4 Items supplied

Impact screwdriver/wrench, operating instructions.
Note
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by us for use with the product can be found at your
local Hilti Center or online at: www.hilti.com
4 Technical data
4.1 Impact screwdriver/wrench
Rated voltage
Weight in accordance with EPTA proce-
dure 01/2003
Rated speed under no
load
Impact speed
Torque adjustment
Large standard bolts
Large high-strength bolts
Socket/bit drive
18
Printed: 16.06.2015 | Doc-Nr: PUB / 5071661 / 000 / 03
Meaning
•
•
•
•
•
SID 14­A
14.4 V
1.3 kg
Setting I 0 rpm ... 1,000 rpm
Setting II 0 rpm ... 1,500 rpm
Setting III 0 rpm ... 2,500 rpm
≤ 3,100 bpm
3 settings
M8 to M16
M6 to M12
/ " hex. socket with lock-
1
4
ing ring
Charge status: 75 % to 100 %
Charge status: 50 % to 75 %
Charge status: 25 % to 50 %
Charge status: 10 % to 25 %
Charge status: < 10 %
SIW 14­A
14.4 V
1.3 kg
0 rpm ... 1,000 rpm
0 rpm ... 1,500 rpm
0 rpm ... 2,300 rpm
≤ 3,400 bpm
3 settings
M8 to M16
M6 to M12
/ " square drive with
1
2
ball-notch retention
or /
3
8
locking ring
" square drive with