Hilti SID 14­A Manual De Instrucciones página 27

5.2 Fitting the belt hook (optional)
WARNING
Risk of injury! Hazard presented by a falling power tool.
▶ A falling power tool may present a risk of injury to yourself and others. Check that the belt hook is
fitted securely before beginning work.
Note
The belt hook allows the power tool to be attached to a belt worn by the operator. The belt hook can
be fitted to allow attachment on the left or right side of the body.
▶ Fit the belt hook.
5.3 Fitting an accessory tool
SID 14­A
SID 22­A
1. Check that the connection end of the accessory tool is clean.
Result
The connection end is dirty.
▶ Clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
3. Push the accessory tool into the chuck as far as it will go (until it engages).
5.4 Removing the accessory tool
SID 14­A
SID 22­A
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Pull the chuck ring forward and hold it in this position.
3. Pull the accessory tool out of the chuck.
4. Release the chuck ring.
5.5 Fitting an accessory tool
SIW 14­A
SIW 22­A
1. Check that the connection end of the accessory tool is clean.
Result
The connection end is dirty.
▶ Clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
3. Bring the notch in the accessory tool into alignment with the ball on the square drive.
4. Push the accessory tool onto the square drive until it engages.
5.6 Removing the accessory tool
SIW 14­A
SIW 22­A
Printed: 16.06.2015 | Doc-Nr: PUB / 5071661 / 000 / 03
3
4
5
6
7
21