Transport And Storage - Hilti SID 14­A Manual De Instrucciones

6 Care, maintenance, transport and storage
6.1 Care and maintenance of the tool
WARNING
Electrical hazards! Improper repairs to electrical parts may lead to serious injuries.
▶ Electrical parts may be repaired only by trained electrical specialists.
▶ Keep the tool, especially its grip surfaces, clean and free from oil and grease. Do not use cleaning agents
containing silicone.
▶ Never operate the power tool when the ventilation slots are blocked. Clean the air vents carefully using a
dry brush. Do not permit foreign objects to enter the interior of the tool.
▶ Clean the outer surfaces of the tool with a slightly damp cloth at regular intervals.
6.2 Care of the Li­ion battery
▶ Keep the battery clean and free from oil and grease.
▶ Clean the outer surfaces of the tool with a slightly damp cloth at regular intervals. Do not use cleaning
agents containing silicone.
▶ To achieve maximum battery life, stop drawing power from the battery as soon as a significant drop in
the performance of the power tool is noticed.
▶ Charge the batteries using the Hilti chargers approved for use with Li-ion batteries.

6.3 Transport and storage

WARNING
Risk of fire! Risk of short circuiting.
▶ To avoid short circuits and associated heat generation, Li-ion batteries should never be stored or
transported in loose, bulk form and without protective measures.
▶ Remove the battery before transporting or storing the impact screwdriver/wrench.
▶ Observe the nationally and internationally applicable transport regulations when shipping batteries by
road, rail, sea or air.
Note
Ideally, the battery should be stored in a fully-charged state in a dry place that is as cool as
possible. Storing the battery in places subject to high ambient temperatures (e.g. at a window) has
an adverse effect on battery life and increases the rate of self-discharge.
If the battery no longer reaches full charge, it may have lost capacity due to aging or overstressing.
It is still possible to work with this battery. You should, however, soon replace the battery with a
new one.
7 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The power tool doesn't run.
The control switch can't be
pressed, i.e. the switch is
locked.
Running speed suddenly
drops considerably.
Printed: 16.06.2015 | Doc-Nr: PUB / 5071661 / 000 / 03
Possible cause
The battery is not fully inserted.
Low battery.
The forward/reverse selector
switch is in the middle position.
Low battery.
Action to be taken
▶ Push the battery in until it
engages with an audible double
click.
▶ Change the battery and charge
the empty battery.
▶ Push the forward/reverse switch
to the left or right.
▶ Change the battery and charge
the empty battery.
23