Setting The Torque - Hilti SID 14­A Manual De Instrucciones

Rated voltage
Weight in accordance with EPTA proce-
dure 01/2003
Rated speed under no
load
Impact speed
Torque adjustment
Large standard bolts
Large high-strength bolts
Socket/bit drive
4.2 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one electric tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the electric
tool. However, if the electric tool is used for different applications, with different accessory tools, or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise information in accordance with EN 60745
Sound (power) level (L
Uncertainty for the sound
power level (K )
WA
Emission sound pressure
level (L )
pA
Uncertainty for the sound
pressure level (K )
pA
Total vibration (vector sum of three directions), measured in accordance with EN 60745
Vibration emission value when tighten-
ing screws/bolts and nuts of the maxi-
mum permitted size (a
Uncertainty for tightening
screws/bolts and nuts of the maximum
permitted size

4.3 Setting the torque

The torque is selected by way of the torque selector button.
Model SID ...
SID 14­A
SID 22­A
Printed: 16.06.2015 | Doc-Nr: PUB / 5071661 / 000 / 03
SID 22­A
21.6 V
1.5 kg
Setting I 0 rpm ... 1,000 rpm
Setting II 0 rpm ... 1,500 rpm
Setting III 0 rpm ... 2,500 rpm
≤ 3,450 bpm
3 settings
M8 to M16
M6 to M12
1
ing ring
SID 14­A
) 94 dB(A)
WA
3 dB(A)
83 dB(A)
3 dB(A)
SID 14­A
7.5 m/s²
)
h
1.5 m/s²
/ " hex. socket with lock-
4
SIW 14­A SID 22­A
94 dB(A) 97 dB(A)
3 dB(A) 3 dB(A)
83 dB(A) 86 dB(A)
3 dB(A) 3 dB(A)
SIW 14­A
7.5 m/s²
1.5 m/s²
SIW 22­A
21.6 V
1.5 kg
0 rpm ... 1,000 rpm
0 rpm ... 1,500 rpm
0 rpm ... 2,300 rpm
≤ 3,500 bpm
3 settings
M8 to M16
M6 to M12
/ " square drive with
1
2
ball-notch retention
or / " square drive with
3
8
locking ring
SIW 22­A
97 dB(A)
3 dB(A)
86 dB(A)
3 dB(A)
SID 22­A SIW 22­A
11 m/s² 11 m/s²
1.5 m/s² 1.5 m/s²
19