Adjustments; Blade Square To Table (90°); Blade Alignment - Bosch 3918 Instrucciones De Funcionamiento Y Seguridad

Adjustments

Disconnect battery pack from tool
!
WARNING
before performing any assembly,
adjustments, changing accessories, or storing the tool.
Such preventive safety measures reduce the risk of starting
the tool accidentally.
NOTE: Your compound miter saw was completely adjusted
at the factory. However, during shipment, slight misalignment
may have occurred. Check the following settings and adjust
if necessary prior to using this compound miter saw.
Blade Square to Table (90°)
Rotate table 1 to 0° position and lock in place.
1.
2. Lower the blade 2 and engage the lock pin 3. Use a
combination square 4 to check blade squareness to
table. Place the square on the table and press it against
the blade. If the blade does not contact the full length of
the square, (Figure 6) follow the alignment procedure.
90° Blade Alignment
a. Move sliding fence to proper position. (See Sliding
Fence on page 54.)
b. Loosen bevel lock handle 5.
c. Loosen jam nut 6 using blade wrench supplied in
the handle, and lower 0° stop screw 7 with the
3 mm hex wrench provided.
d. Grasp carrying handle, move the head assembly
left or right until blade makes contact with the full
length of the square.
Tighten bevel lock handle 5.
e.
Adjust 0° stop screw 7 so that the hex screw head
f.
hits the 0° stop at the same time the blade makes
contact with the full length of the square. Tighten
jam nut 6 (Figure 7).
FIG. 6
3
4
FIG. 7
5
34
2
1
6
7