Adjustments; Blade Square To Table (90°) - Bosch 4405 Instrucciones De Funcionamiento Y Seguridad

Adjustments
Disconnect plug from power source
before performing any assembly,
adjustment or repair to avoid possible injury.
NOTE: Your slide compound miter saw was com-
pletely adjusted at the factory. However, during ship-
ment, slight misalignment may have occurred. Check
the following settings and adjust if necessary prior to
using this compound miter saw.
.
2.
.
4.
Blade Square (90 °)
To Table
90 ° Blade Alignment Check
Rotate table to 0° position and lock in place.
Make sure head assembly is pushed back fully
against stop and slide rail lock knob is tightened.
Lower head assembly. Lock in place.
Use a combination square to check blade square-
ness to table. Place the combination square on
the table and press it against the blade. If the
blade does not contact the full length of the
square, (Figure 6) follow the alignment procedure.
0 ° Stop
Screw
Jam
Nut
Figure 7. Bevel 0 ° Stop Screw and Jam Nut
7. Adjust bevel indicator. Loosen screw and
align indicator to the 0° mark. Tighten screw
(Figure 8).
Combination
Square
Blade
Figure 6. Blade Square to Table
90 ° Blade Alignment Adjustment
1. Loosen bevel lock handle.
2. Move the head off of the 0° stop.
3. Lower 0° stop screw and jam nut with 12mm
or adjustable wrench.
4. Move the saw back to 0° stop.
5. Push square against blade (fig. 6).
6. Adjust 0° bevel stop screw with 12mm or
adjustable wrench until the blade makes
contact with the full length of the square.
Tighten jam nut (Figure 7).
Figure 8. Bevel Indicator
Adjust
to 0°
Bevel
Indicator
Screw
13.