Symbols; Operator's Manual; Features; Product Specifications - Hart HPCS01 Manual Del Operador

SYMBOLS

The following signal words and meanings are intended to explain the levels of risk associated with this product.
SYMBOL SIGNAL
DANGER:
WARNING:
CAUTION:
NOTICE:
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the product better and safer.
SYMBOL NAME
Safety Alert
Read
Operator's
Manual
Eye Protection
Wet
Conditions
Alert
No Hands
Symbol
Recycle
Symbol
V Volts
min Minutes
Direct Current
No Load
n o
Speed
.../min Per Minute

FEATURES

PRODUCT SPECIFICATIONS

Blade Diameter .......................................................6-1/2 in.
Blade Arbor ............................................................... 5/8 in.
Cutting Depth at 0º ...............................................2-1/16 in.
MEANING
Indicates a hazardous situation, which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation, which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation, that, if not avoided, may result in minor or moderate injury.
(Without Safety Alert Symbol) Indicates information considered important, but not related
to a potential injury (e.g. messages relating to property damage).
DESIGNATION/EXPLANATION
Indicates a potential personal injury hazard.
To reduce the risk of injury, user must read and understand operator's manual before
using this product.
Always wear eye protection with side shields marked to comply with ANSI Z87.1.
Do not expose to rain or use in damp locations.
Failure to keep your hands away from the blade will result in serious personal injury.
This product uses lithium-ion (Li-ion) batteries. Local, state or federal laws may prohibit
disposal of batteries in ordinary trash. Consult your local waste authority for information
r egarding available recycling and/or disposal options.
Voltage
Time
Type or a characteristic of current
Rotational speed, at no load
Revolutions, strokes, surface speed, orbits etc., per minute
5 - English
Cutting Depth at 45º .............................................1-7/16 in.
Cutting Depth at 56º ...............................................1-1/8 in.
Cutting Speed ..................................................... 4,700/min