stayer PR12EK Manual De Instrucciones página 14

FINE ADJUSTMENT
When the approximate depth has been set and locked, a
finer adjustment may be carried out by using micro
adjustment knob "D". This knob includes a rotation
indicator that is movable independently from the
adjustment knob. A complete turn of the knob is equal to 1
mm (fig. 8). An additional adjustment (depth of penetration)
may be achieved by means of the knurled screw at the
bottom of the depth scale, stop "H" (fig. 9).
CUTTING IN MULTIPLE RUNS
This machine is equipped with a turret mechanism
establishing the maximum cutting depth by means of seven
stages. Each step of the turret is approximately to 3 mm
cutting depth. Adjust the desired depth with the turret depth
scale starting from its minimum stop.
This depth is set in a maximum of seven steps. Rotate the
turret so that the highest configuration is aligned with the
depth stop screw and complete the first step. Rotate the
turret to beside the most suitable cutting depth and
complete the following step. Repeat this procedure until the
required depth has been achieved.
USING THE PARALLEL GUIDE
Parallel guide "A" may be used to make a cut at a distance
that is parallel to the edge of the work piece. Slide the
parallel guide to the desired cutting distance. By positioning
the guide bars at the bottom of the cutter, and secure with
the fixing knob "R".
Fine adjustment may be achieved by loosening the central
locking knob "F" of the parallel guide and rotating the fine-
adjustment knob (fig. 3); secure again with locking button.
To carry out the operation, firmly hold the stop of the parallel
guide at the edge of the work piece.
USING THE HOLE-CUTTING ATTACHMENT
To use the hole-center cutting accessory, first remove the
guide mechanism and only one of the rods which support it.
Place center-cutting accessory "P" on the rod which
remains installed at the machine (figs. 11-12). Carry out the
circular cut taking into account the radius of the (fig. 11).
USING THE MACHINE'S ROUTER
Router base "O" is used for making a pre-cut or a cut with a
to-be-measured template, and may be used only jointly with
the dust extraction unit. To assemble the router base, you
must remove the three screws that fasten the dust
extraction unit, and install the router base at the base of the
cutter, and secure it with the tree fastening screws (fig. 13).
The router base is now ready to follow the profile as
reproduced by the outline of the template.
TEMPLATE SIZE
The size of the template will be determined by the size of the
cutter to be used. Take into account the indications in
figures 11-15 when calculating the overlap distances.
ENGLISH
11
CUTTING DIRECTION
To avoid vibrations in the cutter and to obtain a better result,
11