Operation - Ryobi RY41140 Manual Del Operador

TOOLS NEEDED
See Figure 3.
The following tools (not included or drawn to scale) are
needed for assembly:
 Phillips screwdriver
ATTACHING GRASS DEFLECTOR
See Figures 4 - 5.
WARNING:
The line cutting blade on the grass deflector is sharp.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Never use blades, flailing devices, wire or rope on this
product. Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps, etc.
Tighten securely all fasteners and caps and do not operate
this product until all missing or damaged parts are replaced.
Please call 1-800-242-4672 or contact an authorized service
center for assistance.
CONNECTING TO POWER SUPPLY
See Figure 6.
This product is designed with a cord retainer that prevents
the extension cord from being pulled loose while using.
 Form a loop with the end of the extension cord.
 Insert loop portion of extension cord through opening in
the bottom of the rear handle and place over cord retainer.
ASSEMBLY
Remove supplied screws with a phillips screwdriver from

the motor
 Line up the screw holes in the grass deflector with the
holes in the motor housing.
 Install supplied screws and tighten by turning clockwise
with a phillips screwdriver.

OPERATION

 Slowly pull loop against cord retainer until the slack is
removed.
 Plug product into extension cord.
NOTE: Failure to remove all excess cord slack from ex-
tension cord retainer could result in plug loosening from
receptacle.
NOTE: Use only approved outdoor extension cords.
CAUTION:
Always use cord retainer to properly attach extension
cord to string trimmer. Failure to use cord retainer may
result in damage to string trimmer and/or extension cord.
STARTING/STOPPING THE TRIMMER
See Figure 6.
 To start the string trimmer, press the switch trigger.
 To stop the string trimmer, release the switch trigger.
ADJUSTABLE FRONT HANDLE
See Figure 7.
The angle of the front handle can be adjusted 180°.
 Unplug the string trimmer.
 Set the trimmer on a flat surface and turn the knob
counterclockwise to loosen the handle.
 For trimming, adjust the handle upward.
 For edging, adjust the handle downward.
 Turn the knob clockwise until the handle is securely
tightened.
Page 8 — English
housing.