Care And Cleaning; Replace Drum Light; Reverse The Door - Maytag MD-3 Guía De Usuario

C C
ARE AND CLEANING
Control Panel – Clean with a soft, damp cloth. Do
not use abrasive substances. Do not spray cleaners
directly on the panel.
The control panel finish could be damaged by some
laundry pre-treatment soil and stain-remover products.
Apply such products away from the dryer and wipe up
any spills or overspray immediately.
Tumbler – Remove any stains such as crayon, ink pen
or fabric dye (from new items such as towels or jeans)
with an all-purpose cleaner. Then tumble old towels or
rags to remove any excess stain or cleaning substance.
Once these steps are done, stains may still be visible,
but should not transfer to subsequent loads.
R R
EPLACE DRUM LIGHT
Instructions for replacing the bulb:
1) Unplug or disconnect the dryer from the electrical
power supply.
2) Open the door and use a screwdriver to remove the
screw attaching the light cover.
3) Remove light cover.
4) Rotate bulb counter-clockwise to remove from
socket.
R
EVERSE THE DOOR
Instructions for reversing the dryer door:
1) Remove 2 hinge screws holding door hinge in place.
2) Remove the door and lay carefully aside.
3) Remove 2 hinge screws on the opposite side of door hinge.
4) Remove 2 screws on the door catch plate.
5) Move door catch plate to opposite side and attach with screws.
6) Move the door to the opposite side and replace 2 hinge screws.
7) Replace 2 hinge screws in opposite holes.
Stainless Steel Tumbler (select models) – To
clean the stainless steel tumbler, use a damp cloth with
a mild, non-abrasive cleaner suitable for stainless steel
surfaces. Remove the cleaner residue and then dry with
a clean cloth.
Dryer Exterior – Clean with a soft, damp cloth. Do
not use abrasive substances. Protect the surface from
sharp objects.
Dryer Exhaust System – Should be inspected and
cleaned once a year to maintain optimum performance.
The outside exhaust hood should be cleaned more fre-
quently to ensure proper operation. (Refer to the
Installation Instructions for more information.)
( )
SELECT MODELS
5) Replace the bulb with a 120 volt, 10 watt, E12 type
6) Turn the light bulb clockwise into socket.
7) Replace light cover.
8) Reinstall the screw into the light cover screw hole.
9) Reconnect dryer to power supply.
10
light bulb.