Storage; Cleaning; Troubleshooting - Gardena 6000 Manual De Instrucciones

1777_20.960.07_Tauch_GB

5. Storage

Storage:
Disposal:
(in accordance with
RL2002/96/EC)

6. Cleaning

Flushing the pump:
Cleaning the suction
base and feed impeller:
s

7. Troubleshooting

Problem
Pump is running,
but oes not deliver.
14
27.07.2011 15:50 Uhr
➔ Clean and store the pump in a frost-free place before the first
frost arrives.
The product must not be added to normal household waste.
It must be disposed of in line with local environmental regulations.
The GARDENA should not require regular maintenance.
After pumping pumped chlorinated swimming pool water or other
liquids leaving residues, the pump should be rinsed with clear
water.
WARNING ! Electric shock !
Risk of injury due to electric shock.
➔ Disconnect the pump from the mains before
cleaning the suction base and feed impeller.
1. Unscrew the cross-head screws
base from the pump.
2. Press snap hooks s together and remove safety cover
suction foot
3. Clean suction foot
4. Refit suction foot
again. During this, ensure that the sealing ring
correctly.
5. Reinsert the safety cover
For safety reasons a damaged feed impeller
exchanged by the GARDENA Service Centre.
WARNING ! Electric shock !
Risk of injury due to electric shock.
➔ Disconnect the pump from the mains before
rectifying faults.
Probable cause
Air cannot escape as
pressure line is closed
(e.g. kinked pressure pipe).
Air locks in the suction base.
Seite 14
and remove the suction
and clean.
and impeller .
and screw in the cross-head screws
in the suction foot
Remedy
➔ Open pressure line.
➔ Wait for max. 60 seconds
until the pump deaerates
automatically over the vent
valve. If necessary, switch
off and start it again.
from
is seated
again.
can only be