Blade Maintenance; Change Oil - KPC BK 500 S Manual De Instrucciones

10.1

Blade Maintenance

Warning! Before removing Top Hopper knob, ensure the machine is
switched off, and the machine is completely stopped.
Warning! If ejection chute becomes clogged or cutting blades become
jammed under no circumstances should you place your hands in ejection
chute to try to clear obstruction, as this will lead to serious injury.
! Switch the machine off, and make sure the machine is completely stopped.
! Loose four screws as shown on carefully lift up the hopper.
! Dismantles bit anchor screw 2pcs with the suitable tool.
! Sharpen or replace the blades, then tighten the screws.
! Closes the hopper, and then tighten the screws.
10.2

Change oil

! Let engine runs out of fuel, and wait until engine stopped and cooled slightly.
! Disconnect spark plug wire and keep away from spark plug.
! When engine is still warm, remove oil drain plug. Drain oil into a proper container.
! Clean the oil drain plug before restoring it back.
! Place engine level. Remove dipstick. Add new recommended oil about0.3L slowly to upper
limit on dipstick, don't overfill.
! Replace dipstick.
Warning! Prevent skin contact with used engine oil. Wash your skin with
soap and water after oil change.
Caution: Used oil is a hazardous waste product. It is suggested to bring
used oil to your local recycling center with properly seald container. Do not
discard with household waste.
P a g e | 14
EN