Installing Accessories - Bosch 1295D Instrucciones De Funcionamiento

BACKING PAD INSTALLATION
The random orbit sander is equipped with a
backing pad of soft hardness, which is
suitable for general service. Harder and
softer pads are available for other purposes,
and in general are used as follows;
Extra soft pad - Polishing or sanding large
or curved surfaces.
Soft pad - All purpose general sanding and
polishing.
Hard pad - Heavy sanding on flat surfaces,
especially with coarser abrasives.
To change backing pad, hold pad firmly and
turn screw counterclockwise with 5mm allen
wrench provided. Remove old pad, and place
new pad over locating pins on drive spindle.
Replace screw and securely tighten in a
clockwise direction with the allen wrench.
Damaged or worn backing pads must be
replaced immediately.
BACKING PAD DAMPER
Your tool is equipped with an integrated
backing pad damper ring. This damper
reduces the no-load speed, which helps
prevent accidental marking of the workpiece
surface and provides uniform finishing.
NOTE: If you notice steadily increasing no-load
speed, this indicates that the damper ring is
worn and needs to be replaced.
To replace damper ring, remove backing pad
as described in "Backing Pad Installation" and
remove worn damper ring by pulling firmly out
(Model 1295D 1295DH & 1295DVS)
Your random orbit sander uses hook-and-loop
backed accessories, which firmly grip the pad
when applied with moderate pressure. To
change the accessory, merely peel off the old
accessory, remove dust from the pad if
necessary, and press the new accessory in
place. Be sure to align the sanding disc holes
with the holes in the backing pad to allow the
dust extraction system to function.
After considerable service the pad surface will
become worn, and the pad must be replaced
when it no longer offers a firm grip. If you are
experiencing premature wearout of the pad
facing, decrease the amount of pressure you
are applying during operation of the tool.

Installing Accessories

-8-
DAMPER RING
SHROUD
of locating groove. Loosen the two screws on
shroud just enough so you can separate
shroud approximately 1/4 inch. Align locating
bumps on damper ring with cut outs in shroud
and depress ring with thumbs until shroud
seats into groove completely around ring, then
tighten screws.
IMPORTANT: Ring should not have bends or
ripples when correctly seated.
Apply a thin film of light grease to top side of
backing pad where the damper ring makes
contact, reassemble backing pad and firmly
tighten screw.
(Model 1295DP only)
Your sander is equipped with PSA backed
accessories with pressure sensitive adhesive.
To change accessory, peel protective sheet
from the back of accessory. Align accessory
with backing pad and press firmly in place. To
remove, lift an edge of accessory with your
finger nail and peel it off the backing pad.
NOTE: Do not store tool with sanding disc on
pad, as sanding creates heat which increases
the adhesive bond. If the disc is left in place it
may become very difficult to remove.
BACKING
PAD
LOCATING
BUMPS ON
UNDERSIDE
OF DAMPER
RING