Installing Accessories - Bosch DGSH181 Instrucciones De Funcionamiento Y Seguridad

BM 2610034444 04-14_DGSH181 4/2/14 11:24 AM Page 10
Disconnect battery pack from tool before making any assembly,
W RNING
adjustments or changing accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
SELECTING GRINDING ACCESSORIES
Before using a grinding wheel
W RNING
point or cone, be certain
that its maximum safe operating speed is
not exceeded by the nameplate speed of
the grinder. Do not exceed the recommended
wheel point or cone diameter of 2 inches.

INSTALLING ACCESSORIES

Be sure that the diameter of
W RNING
the shank is the same size
as the inside diameter of the collet.
To prevent damage to collet,
C UTION
avoid excessive tightening of
the collet nut when there is no accessory inserted.
Only use properly fitting and undamaged
open-end 19 mm wrenches.
1. Place a (19 mm) open-end wrench onto the
spindle to prevent the spindle from rotating
(Fig. 2).
2. Hold wrench in place and rotate collet nut
counter-clockwise with another (19 mm)
open-end wrench.
3. Insert three fourths of shank of accessory
into the collet and securely tighten collet nut
clockwise.
REMOVING ACCESSORIES
Repeat steps 1 and 2 of above and remove
accessory.
Assembly
B
SPINDLE LOCK
WRENCH
SH NK OF
CCESSORY
COLLET
-10-
FIG. 2
19 MM
COLLET NUT
WRENCH
19 MM