Inverting The Output Signal; Application Examples (Pump With Pwm Control); Yonos Para General; About This Document - Resol PSW Basic Manual De Uso

2.3

Inverting the output signal

By means of the three-pole jumper on the left-hand side above the output termi-
nals the output signal can be issued inverted or not inverted.
Jumper position left: not inverted (solar pump)
Jumper position right: inverted (heating pump)
Input
Heating (H)
100%
0%
2.4

Application examples (pump with PWM control)

S
HE pump
Mains
connection
Output signal:
230 V~
PWM
external
Relay output of the controller
for pump speed control
18
Solar (S)
S
Output
PWM
100%
0-10 V
H
Made in Germany
T0,2A
PSW Basic
220 ... 240 V~, 50-60 Hz
N L
Mains connection
230 V~
Input signal:
230 V control
signal from
the controller
(On / Off,
burst / wave
packet, phase
cutting)
Yonos PARA
3 General

About this document

The language of the original operating instructions is English. All other languages of
these instructions are translations of the original operating instructions.
These installation and operating instructions are an integral part of the product.
They must be kept readily available at the place where the product is installed.
Strict adherence to these instructions is a precondition for the proper use and
correct operation of the product.
The installation and operating instructions correspond to the relevant version of
the product and the underlying safety regulations and standards valid at the time
H
of going to print.

EC declaration of conformity:

A copy of the EC declaration of conformity is a component of these operating
instructions.
If a technical modification is made on the designs named there without our agree-
ment or the declarations made in the installation and operating instructions on
product/personnel safety are not observed, this declaration loses its validity.
4

Safety

These operating instructions contain basic information which must be adhered to
during installation, operation and maintenance. For this reason, these operating in-
structions must, without fail, be read by the service technician and the responsible
specialist/operator before installation and operation.
It is not only the general safety instructions listed under the main point "safety"
that must be adhered to but also the special safety instructions with danger sym-
bols included under the following main points.
4.1

Indication of instructions in the operating manual

Symbols:
General danger symbol
Danger due to electrical voltage