Publicidad
• Loosen (Do Not Remove) Terminal Block Screws.
• Limit Switch adjustments and securing the Wires
will be done later.
F
Lay Wires in channel on top of Rail and secure with Wire Clips
(Figure 14).
G
Coil and bundle excess Limit Switch Wires on top of Power
Head with Twist Ties. Leave just enough Wire to reach
Terminals on back of Power Head (Figure 14).
H
Turn Opener upside down, and connect Limit Switch Wires to
Power Head Terminal Block (Figure 15):
•
Terminal 4: OPEN Limit Switch Wire (white).
•
Terminal 5: OPEN Limit Switch Wire (white) and
CLOSE Limit Switch Wire (brown).
•
Terminal 6: CLOSE Limit Switch Wire (brown).
C
H
Assembly Step 7:
• Tie overhand knot at one end of emergency release cord and pull
cord through the hole in the release lever up to the knot
(Figure 16).
• Thread opposite end of cord through knob and tie a knot in this
end also.
• Following installation of your garage door opener, adjust the height
of the knob to no less than 6 feet above the floor.
* The Emergency Release Cord is threaded through the Carriage release
lever at the factory.
C
H
Assembly Step 8:
Please note the following information so it is available if you need
to call us:
Date purchased:
Serial number (Figure 17):
Remote Control Model:
Model number (Figure 17):
Dealer Name:
Dealer Address:
City:
State:
Zip:
Phone:
Please keep original or photocopy of your sales receipt with
this manual for future reference should service ever be
required.
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
NOTE
A
E
TTACH
MERGENCY
R
C
ELEASE
ORD AND
R
O
M
ECORD
PENER
ODEL
S
N
AND
ERIAL
UMBER
________/________/________
_________________________
_________________________
_________________________
_________________________
_________________________
_________________________
_________________________
_________________________
_________________________
NOTE
Antenna
Terminal
Block
Figure 15 Connect Limit Switch Wires to Power
K
NOB
Figure 16 Attach Emergency Release Cord and Knob
Figure 17 Model and Serial Numbers
White Limit
Brown Limit
Switch wires
Switch wires
Head Terminal Block
Serial
Number
(example)
Model
Number
11
Publicidad
Capítulos
