Publicidad
CAUTION
Staples which are too tight may cut or pinch Wires. Cut or
pinched Wires can cause the Safe-T-Beam® System to stop
working. When installing the Insulated Staples, make sure
you fasten them only as tightly as needed to hold the
Wire securely.
OPEN RED PARTS BAG
C
Install Safe-T-Beam® Wiring (Figure 27):
•
Route Wire and Insulated Staples
(Figure 28 and Figure 29).
–
Securely fasten Wires with Insulated Staples as
you go. Staples should be snug only.
–
Wires between garage wall and Power Head should
be run on top of Rail and underneath Wire Clips.
•
Attach Wires to Safe-T-Beam® Sensors.
–
Split and strip Wire ends to be connected as shown.
–
Loosen Terminal Screws.
–
Insert each Wire under flat plate and tighten Screw.
It does not matter which Wire, white or striped, goes
on which Terminal.
•
Attach Wires at Power Head.
–
Wires are connected to Terminals #2 and #3 on
Power Head Terminal Block. It does not matter which
Wire, white or striped, goes on which Terminal.
•
Check the following.
–
Ensure that no part of door or its hardware is in path
between Source or Sensor Lenses.
•
Ensure that tops of Lenses are between 5" – 6" above
floor. Brackets are flexible and can be adjusted slightly
if needed.
The Safe-T-Beam® alignment check will be performed
following connection to electrical power.
Do Not plug in yet!
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
NOTE
Insulated Staples
#6-1
(approximately
Pan Head
30 parts)
Screws
Hardware (red bag)
Approx.
1
/
1
2
Wire
Figure 27 Wire the Safe-T-Beam® System
Wire Clips
at Safe-T-Beam®
Terminal
attachments
at Power Head
Figure 28 Wiring Method A
Wire Clips
attachments
at Safe-T-Beam®
Terminal
attachments
at Power Head
Figure 29 Wiring Method B
1
/
"
Wall
4
Button
"
Strip
approx.
/
"
1
2
Insulated
Staples
Terminal
attachments
Allow slack for
adjustment
Insulated
Staples
Terminal
Allow slack for
adjustment
17
Publicidad
Capítulos
