Operating The Device Safely - Mobicool A40 Instrucciones De Uso

Safety instructions
 If the cooler is connected to the DC socket: Disconnect the
cooler and other power consuming devices from the battery
before connecting the quick charging device.
 If the cooler is connected to the DC socket: Disconnect the
cooler or switch it off when you turn off the engine. Otherwise
you may discharge the battery.
 The cooling device is not suitable for transporting caustic
materials or materials containing solvents.
2.2

Operating the device safely

DANGER!
D
 Do not touch exposed cables with your bare hands. This
especially applies when operating the device with an AC mains
power supply.
CAUTION!
!
 Before starting the device, ensure that the power supply line
and the plug are dry.
NOTICE!
A
 Do not use electrical devices inside the cooler unless they are
recommended by the manufacturer for the purpose.
 Do not place the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
 Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that arises during operation does not build up. Make sure
that the device is sufficiently far away from walls and other
objects so that the air can circulate.
 Ensure that the ventilation openings are not covered.
 Do not fill the inner container with ice or fluid.
 Never immerse the device in water.
 Protect the device and the cable against heat and moisture.
 Ensure that the ventilation slots are not covered.
Keep to the following distances to the ventilation openings:
– a gap of at least 10 cm at the rear
– a gap of at least 5 cm on either side
8
A40
EN