Usb Connection - OHAUS RANGER 3000 Manual De Instrucciones

EN-2
2. Install the Interface PCB. Push it through the pins and secure it with the 4 screws.
Pins
Groove
for cable
3. Connect a USB Cable.
4. Place the cord in the groove and put the red interface option cover back on.

USB CONNECTION

The USB cable terminates with a 4-pin, male, USB Type A connector.
1. Power on the computer and verify that the USB port is enabled and working properly.
2. Plug the cable's USB connector into the computer's USB connector. Windows® should detect a
USB device and the New Hardware Wizard will be initialized.
USB Interface
Screws