Usb Connection - OHAUS TAJ602 Manual De Instrucciones

EN-2

USB CONNECTION

The USB cable terminates with a 4-pin, male, USB Type A connector.
1. Power on the computer and verify that the USB port is enabled and working properly.
2. Plug the cable's USB connector into the computer's USB connector. Windows® should detect a
USB device and the New Hardware Wizard will be initialized.
VIRTUAL PORT SOFTWARE INSTALLATION
1. Insert the supplied CD into the CD drive.
Different versions of Windows® have slightly different steps to load the driver that is on the CD.
In all versions the New Hardware Wizard guides you through the required steps to select the
driver that is located on the CD.
Example of Windows XP Hardware Wizard
2. After clicking Finish, the virtual port should be ready for use.
Windows® typically adds the virtual port in sequence after the highest number COM port. For
example, on PC's equipped with up to 4 COM ports, the virtual port will be COM5.
When using the USB interface with programs that limit the number of COM port designations
(e.g. Ohaus MassTracker allows only COM1, 2, 3, & 4), it may be necessary to assign one of
these port numbers to the new virtual port. This can be done in the Port Settings of the Device
Manager utility, found in the Windows Control Panel.
USB Interface