Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING THE SADDLE HEIGHT.-
Loosen the saddle post adjustment
knob
(16)
slightly
anticlockwise, Fig.8, move the saddle
to a position comfortable for doing
exercise
and
adjustment knob (16) securely by
turning it clockwise.
Stay within the references.
HORIZONTAL ADJUSTMENT OF
THE SADDLE.-
Loosen the knob (20) slightly by
turning it anticlockwise, Fig.8, move
the saddle to a position comfortable
for doing exercise and then tighten the
knob (20) securely by turning it
clockwise.
Stay within the references.
7.- FITTING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on either the pedal or
the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal, marked with the
letter (23R), screws onto the right-
hand crank, also marked with an (R),
in a clockwise direction. Tighten
securely, Fig.9.
The left-hand pedal, marked with the
letter (23L), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely, Fig.9.
ADJUSTING THE BRAKE.-
You can increase or decrease the
braking tension on the machine by
means of the tensioner control (64).
by
turning
then
tighten
direction.
Tighten
Fig.10.
During exercise the flywheel will get
it
hot due to the braking effect, so when
you have finished exercising it is
advisable to set the tensioning control
the
to minimum in order to help stop the
brake shoe from hardening.
Important: This tensioning control
(63) is equipped with an emergency
braking system which, when applied
with force (as shown by the arrow in
Fig.10, produces a much sharper
braking effect.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (11) up or down, as
shown in Fig.11.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (14)
Fig.12, to make it easier to move. The
wheels located at the front of your unit
make it easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.12. Store your unit in a dry place,
preferably not subject to changes in
temperature.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
12
Publicidad
