Orbegozo DS 61190 IN Manual De Instrucciones página 18

DS 61190 IN
PROBLEMS AND SOLUTIONS
Problem
Light on but motor
does not work
Light does not work,
motor does not work
Oil leakage
Shake of the body
Insufficient suction
The Hood inclines
ELECTRICAL DIAGRAM.
Cause
The leaf blocked
The capacitor damaged
The motor jammed bearing damaged
Beside the above mentioned, check the following:
Light damaged
Power cord looses
One way valve and the air ventilation
entrance are not tightly sealed
Leakage from the connection of U-
shaped section and cover
The leaf damage and causes shaking
The motor is not tightly hanged
The body is not tightly hanged
The distance between the body and the
gas top too long
Too much ventilation from open doors
or windows
The fixing screws are not tight enough
The hanging screw is not tight enough
Solution
Get rid of the blocking
Replace capacitor
Replace the motor
Replace lights
Connect the wires as per the electric
diagram
Take down the one way valve and seal
with glue
Take U-shaped section down and seal
with soap or Paint
Replace the leaf
Lock the motor tightly
Fixed the body tightly
Readjust the distance
Choose a new place and resemble the
machine
Tighten the hanging screw and make
it horizontal
Tighten the hanging screw and make
it horizontal
MAIN PARAMETERS
Rated Input 220V-240V, 50Hz
Rated Power 234W
Lighting Power 2WX2
Motor Power 230W
Drive Mode Single Motor
Speed Speed I Speed II Speed III
Air tube diameter 150MM
Air output ≥619.3m3/h
Air pressure ≥462Pa
Noise ≤71dB(A)
18