To Examine The Battery And The Battery Charger; To Clean The Product, The Battery And The Battery Charger; Troubleshooting - RedMax BHB250P Manual Del Usuario

To do a check of the air intake
1. Make sure that the air intake is not blocked on any
side on the product.
2. Stop the product and remove leaves or unwanted
material if necessary.
CAUTION: A blocked air intake
decreases the blowing capacity of the
product and increases the motor's
Keypad
LED display
Green activate LED flashing
Red error LED flashing
The product does not start
Error LED is lit with red light
Battery
LED display
Green activate LED flashing
12

Troubleshooting

Possible faults
Low battery voltage.
Overload.
Temperature deviation.
The power trigger and the acti-
vate button are pressed at the
same time.
Dirt in the battery connectors.
The product needs servicing.
Possible faults
Low battery voltage.
working temperature. This can result in
motor failure due to overheating.
To examine the battery and the
battery charger
1. Examine the battery for damages, for example
cracks.
2. Examine the battery charger for damages, for
example cracks.
3. Make sure that the battery charger connection wire
is intact and that there are no cracks in it.
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after use.
2. Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
3. Make sure that the terminals on the battery and the
battery charger are clean before the battery is put in
the battery charger or the product.
Possible action
Charge the battery.
The cutting attachment is jammed. deacti-
vate the product. Remove the battery. Clean
the cutting attachment from unwanted mate-
rials.
Let the product cool down.
Release the power trigger and the product is
active.
Clean the battery connectors with com-
pressed air or a soft brush.
Contact your servicing agent.
Possible action
Charge the battery.
471 - 004 - 04.09.2018