Sartorius stedim Flexel Palletank 50L Manual De Usuario página 12

Figure 22.
F. On the table, position the bag in such a
way that the protective shield (red compo-
nent) is uppermost. Remove the protective
shield (red component) which is magnetically
attached below the bag (there is no need to
remove its pouch) (See Fig. 23)
Figure 23.
G. Position first the hole of the centering
aligner in the dedicated fitting on the
bag. Position then the magnetic clamp.
(See Fig. 24)
Figure 24.
12
H. To position the bag inside the Palletank
- Hold the folded bag on both arms with the
magnetic clamp assembled to the centering
aligner at the bottom and the 4-port sys-
tem in front of you (See Fig. 25) - This
correct positioning will ensure a proper
insertion of the Bag in the Palletank
- Position yourself in front of the Palletank
Figure 25.
I. Introduce the folded bag in the Palletank
by the front opening and insert the magnet-
ic clamp with its aligner in the drive-bag
interface (See Fig. 26).
Figure 26.
J. Remove the adhesive tape and the foam
from the Flexel ® Bag for LevMixer
(See Fig. 27). Unfold the bag and position
the 4-port system in the dedicated front
gate and the tubing in their holder.
K. Close the front 4-port system gate
by sliding it in its dedicated area.
L. Check that no tube is trapped in the
®
Palletank .
® :
®
®
.
Figure 27.
M. Close the hinged front door and secure
the locking systems (See Fig. 28). Do not
start filling the bag prior to closing the door.
® N. Position the clamps on the tubes as close as
possible to the bottom port and close them.
Figure 28.
®