Corghi LaserLine EM 9550 Manual De Uso página 54

- Modify the width value displayed by pressing
the
value is set.
The WIDTH can be set in millimetres or the
values already set can be converted from inches
to millimetres by pressing the
Keep the
rapidly increase or decrease the previously
set values.
After completing the wheel data update, press
the button to exit and display the un-
balance values recalculated according to the new
dimensions, or to perform a wheel spin.
- if two subsequent measurements are taken
inside the rim on two balancing planes, the
machine interprets the presence of a rim with
balancing using a clip weight on the inner
plane and an adhesive weight on the external
one (ALU 2P).
In this phase, the machine could automatically
change the type of weight on the inner plane from
clip to adhesive (ALU 1P). The operator is able
to change this setting by pressing the
button. In this case, the balancing programme
switches from ALU 1P to ALU 2P and vice versa.
54
17
buttons until the desired
button.
keys pressed to
Wheel data entry for wheel
balancers with an ultrasonic
sensor (if present)
To enter the distance, diameter and width values
automatically, proceed as follows:
- bring the automatic internal measuring arm into
contact with the inner side of the rim (fig.16)
During this phase, the graphic shown in figure
16a will appear on the display.
Take great care to position the arm correctly so
as to ensure accurate data reading.
- Keep the arm in contact with the rim until the
machine has acquired the wheel's diameter and
distance values. During this phase, the graphic
shown in figure 16b will appear on the display.
- if only one measurement is taken, the machine
interprets the presence of a rim with balanc-
ing using a clip weight (Dynamic Balancing
Programme)
- when the automatic internal measurement arm
returns to the rest position, "Lr" will appear
automatically on the left display and the type
of wheel will be shown on the right display:
- P (Passenger Tyre) for medium sized wheels
(wheels with a tyre shoulder that does not
protrude much from the rim);
- Lt (Light Truck Tyre) for large sized wheels
(such as off-road, trucks or wheels with a tyre
shoulder that protrudes considerably from
the rim).
- use the arrow buttons
the type of wheel being used
- If you press the
indicated above, the width can be entered
manually using the keypad.
- in this phase, it is possible to perform a new
acquisition of the rim planes.
- lowering the guard confirms the selection that
was made (manual width entry or wheel type
selection) and a spin is performed and the
wheel width is automatically measured.
Note:
- automatic width acquisition is re-enabled only
with a new acquisition of the automatic internal
measuring arm;
- if the wheel guard is closed or in the case of a
fault of the sensor located on the guard, the
machine will automatic setup for manual width
entry when the internal measuring arm is moved
EM 9550 - Operator's manual
to select
button in the phase