Direct Button Function Configuration; Important; Additional Ringtone; Bell Push - Vimar Eikon 20557.N Manual Del Instalador

DIRECT BUTTON FUNCTION
CONFIGURATION
Buttons "B" and "C" can be configured at will by sending
commands via the BUS that differ from the default settings
(respectively AUX SERVICE 1 and LOCK); to configure but-
tons "B" and "C" without the programmer and/or personal
computer, carry out the following operations:
• Unhook the cover of button "B" (auxiliary function) (fig-
ure 1) .
• Press and hold button "R" located below the ringtone
volume trimmer (figure 2) .
• Press and hold the button you want to set ("B" or "C") and
the hands free button "A" at the same time; release button
"R" . The door entryphone will emit a beep to confirm the
setting and you can then release the buttons . If no beep is
emitted at this stage, repeat the procedure .
• Once the beep has sounded, the door entryphone has
been coded and now needs to receive the save command
(sent from the PC USB interface and "SaveProg" software .
For configuration details, refer to technical documentation .

IMPORTANT

During coding operations, take care not to assign the same
code to more than one device . Needless to say, it is very
important to keep a record of the codes assigned to the
devices in the system (also useful in the event of expanding
the system at some time in the future) .

ADDITIONAL RINGTONE

To install additional call repeaters, use type '5' terminals
(supply +12 V DC max 40 mA) and '6S' (GND command) to
power a suitable external supporting relay .

BELL PUSH

An additional NO button can be installed to act as the bell
push .
Use terminals '4' and '6P' .
21 - ENGLISH