Safety Regulations - Corghi A 2030 Manual De Uso

The machine is equipped with a pressure regulator set at 10 bar (standard machine op-
eration). If you are working with easily deformable rims (motor cycle wheels for example)
we recommend lowering the pressure temporarily to 7 or 8 bar.
ATTENTION
For correct and safe operation of the machine it must be connected to an efficient
grounding circuit.
NEVER connect the ground wire to a gas pipe, water pipe, telephone line or other
makeshift system.
Before making the electrical and pneumatic hook-ups, make sure that the machine is
configured as described below (fig.5):
- pedals A and B (if present) in fully depressed position.
- tower C vertical (not tilted).

SAFETY REGULATIONS

The equipment is intended for professional use only.
WARNING
Only one operator may work on the equipment at a time.
WARNING
Failure to observe these instructions and the relative danger warnings can cause seri-
ous injury to the operator and others. Do not power up the machine before you have
read and understood all the danger/warning/attention notices in this manual.
This machine must be used only by qualified and authorised personnel. A qualified operator
is construed as a person who has read and understood the manufacturer's instructions, is
suitably trained, and is conversant with safety and adjustment procedures to be adhered
to during operations. Operators are expressly forbidden from using the machine under
the influence of alcohol or drugs capable of affecting physical and mental capacity.
The following conditions are essential:
- The operator must be able to read and understand all the information in this manual.
- Make sure you have a thorough knowledge of the capabilities and characteristics of this
machine.
- Keep unauthorised persons well clear of the area of operations.
- Make sure that the machine has been installed in compliance with established legisla-
tion and standards.
- Make sure that all machine operators are suitable trained, that they are capable of using
the machine correctly and that they are adequately supervised during their work.
- Never leave nuts, bolts, tools or other equipment on the machine to avoid the risk that
they could become entrapped between moving parts during work.
- Do not touch power lines or the inside of electric motors or other electrical equipment
A 2030 - A 2025 - A 2020 - A 2015 - A 2005 operator's manual
A 2015, A 2020, A 2025 and A 2030 only
GB
39