Replacing Carbon Brushes - Makita BGA450 Manual De Instrucciones

Esmeriladora angular inalámbrica
Ocultar thumbs Ver también para BGA450:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
2
007222
The tool and its air vents have to be kept clean. Regularly
clean the tool's air vents or whenever the vents start to
become obstructed.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Insert the top end of slotted bit screwdriver into the notch
in the tool and remove the holder cap cover by lifting it
up.
1
007226
1. Exhaust vent
2. Inhalation vent
1. Limit mark
1
1. Holder cap
cover
2. Screwdriver
2
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
1
2
007223
Reinstall the holder cap cover on the tool.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These
accessories
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
Your tool is supplied with a guard for use with a
depressed center grinding wheel, multi-disc,
diamond wheel, flex wheel and wire wheel brush. A
cut-off wheel can also be used with an optional
guard. If you decide to use your Makita grinder with
approved accessories which you purchase from
your Makita distributor or factory service center, be
sure to obtain and use all necessary fasteners and
guards as recommended in this manual. Your
failure to do so could result in personal injury to you
and others.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Various type of Makita genuine batteries and
chargers
9
1. Brush holder cap
2. Screwdriver
or
attachments
Only use
accessory or
are

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Bga452

Tabla de contenido