Rothenberger ROMAX AC ECO Instrucciones De Uso página 11

that cannot be controlled with the switch is
dangerous and must be repaired.
c) Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any
adjustments, changing accessories, or
storing power tools. Such preventive safety
measures reduce the risk of starting the power
tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tools operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
Keep cutting tools sharp and clean.
f)
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and tool
bits etc., in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for
operations different from those intended could
result in a hazardous situation.
5) Service
Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
Special Safety instructions
The term press jaw also includes main Jaw, press
ring and press chain.
Never hold your fingers or other body parts in the
working area of the cylinder or the pressing jaws.
Disconnect the plug from the socket before
carrying out any work on the machine. If the
device is so badly damaged that electric cables or
drive parts are exposed, disconnect the mains plug
immediately and contact your service outlet.
Unauthorised repair work may result in the user
suffering major injuries or even death.
Only personnel trained in how to use the device
may make crimp pipe joints using the ROMAX®
AC ECO.
The machine may only be used with a press jaw
inserted into it. The press jaw must be in perfect
technical condition.
Only start the machine if it is in perfect working
order.
Servicing and repair work may only be carried out
by workshops authorised by ROTHENBERGER.
Use only suitable press jaw and press fitting
systems that have been approved by
ROTHENBERGER Werkzeuge GmbH.
After you have inserted the press jaw check that
the bolt is securely locked.
In the event of problems during the pressing
process, press the EMERGENCY STOP button.
Check that the pipe joint is secure after you have
completed the pressing process.
Imperfect pipe joints must be compressed again
using a new fitting.
Follow the installation instructions supplied by the
fitting and pipe manufacturers.
Assure by pressing leaky press fittings, that no
humidity respectivily lotic water reaches into the
inside of the machine!
After finishing the work, check the installation with
appropriate testing equipment and assure, that it is
leakproof!
ENGLISH
7