Mains Connection - Rothenberger ROMAX AC ECO Instrucciones De Uso

Proper usage
The ROMAX® AC ECO is designed exclusively for the use of pressing jaws manufactured by
ROTHENBERGER or that have been declared suitable by ROTHENBERGER, for example the products
available from MAPRESS, Viega, Geberit, Uponor, etc.
The device and the press jaws are designed exclusively for crimp fittings, for which the corresponding
pressing jaws have been designed. Any other or additional use shall be deemed improper.
ROTHENBERGER cannot accept any liability for the resultant consequences and damage, nor for the use of
pressing jaws from other manufacturers, nor for damage caused by these pressing jaws.
Proper usage also includes compliance with the operating manual, compliance with the inspection and
servicing conditions and adherence to all the relevant safety regulations.
The ROMAX® AC ECO is a handheld electric machine and must not be used for stationary applications.
This device may only be used correctly as described.
Technical data
Voltage .......................................................................................
Rated power consumption........................................................... 280 W
Motor speed ............................................................................... 14000 min-1
Maximum piston force ................................................................ 32 kN
Pressing time (according to nominal size) ..................................... approx 6-8 s
Dimensions (LxWxH) ................................................................... 410x80x170 mm
Weight ...................................................................................... approx 5 kg
Working range ........................................................................... ø12-110 mm (system- dependent)
Application temperature range .................................................... 0-40 °C
Protection type ........................................................................... IP 20
Protection class ........................................................................... II
Operating mode.......................................................................... S3
Typical acceleration in hand-arm area .......................................... ≤ 2,5 m/s2
Sound pressure level (L
Sound power level (L
WA
The noise level during operation can exceed 85 dB (A). Wear ear protection.
Measurements found in compliance with EN 60745-1.

Mains connection

Connect only to single-phase alternating current
and only to the mains voltage specified on the
rating plate. The machine may also be connected
to sockets without an earth contact since it
complies with protection class II.
EMERGENCY STOP button
If there is any danger to personnel or the machine
during the pressing process, press the EMERGENCY
STOP button immediately and release the ON
switch. The valve will open and the piston will
return to its initial position.
8
)............................................................ 71 dB (A) ¦ K
pA
) ............................................................. 82 dB (A) ¦ K
230V (110V)
To switch on
Press one of the two ON buttons until the pressing
process has been completed.
To insert the press jaw
Disconnect the mains plug!
A
1
Open the bolt.
2 Insert the appropriate press jaw for the job in
hand.
3 Lock the bolt.
After changing the crimping jaw it is essential to
ensure that once engaged, the crimping jaw
matches the profile being moulded and the
nominal width of the fitting being moulded. A
ENGLISH
3 dB (A)
pA
3 dB (A)
WA
B
C