Service; Fixing Malfunctions; Normal Operating Noises Of The Cooktop - Bosch NIT8666SUC/01 Manual De Uso Y Cuidado

Service
Fixing Malfunctions
Malfunctions are usually due to small details. Before
calling the Technical Assistance Service, you should
consider the following advice and warnings.
• , CAUTION
Repairs should only be done by a trained servicer.
Improper repair of your appliance may result in risk
of severe physical injury or death.
Indicator Malfunction Solution
none
The electric power supply has been cut
off.
The appliance has not been correctly
connected following the connection
diagram.
Electronic system malfunction.
Use other electrical appliances to check whether
there has been a power cut.
Check that the appliance has been connected
correctly according to the connection diagram.
If the measures above cannot resolve the
malfunction, contact the Technical Assistance
Service.
The indicators flash The control panel is damp or an object is Dry the control panel area or remove the object.
resting on it.
The indicator - flashes A fault has occurred in the electronic Briefly cover the control panel with your hand to
on the cooking zone system, confirm the malfunction.
indicators
E
,- -- number / o -- Electronic system malfunction. Unplug the cooktop from the mains. Wait about
number / _ -- number 30 seconds before plugging it in again.*
F_ r_
u / ,-_ There is an internal operating error. Unplug the cooktop from the mains. Wait about
30 seconds before plugging it in again.*
c The electronic system has overheated Wait until the electronic system has cooled down
and the corresponding burner has been sufficiently. Then touch any symbol on the
turned off. cooktop. *
/--'4 The electronic system has overheated
and all burners have been turned off.
F,-
-- power level and There is a hot pan on the control panel. It Remove that pan. The malfunction indicator will
beep is highly likely that the electronic system turn off shortly afterwards. You can carry on
will overheat, cooking.
F,-
and beep There is a hot pan on the control panel. Remove that pan. Wait a few seconds. Touch
The burner has turned off to protect the any key on the control panel. When the
electronic system, malfunction indicator turns off, you can carry on
cooking.
" ' Incorrect supply voltage, outside normal Contact your electricity distributor.
U ,
operating limits.
Lac / L,3 The burner has overheated and has Wait until the electronic system has cooled down
turned off in order to protect its cooking sufficiently before turning it back on.
surface.
• If the warning persists call the Technical Assistance Service.
Do not rest hot pans on the control panel.
Normal operating noises of the cooktop
Induction technology is based on the creation of
electromagnetic fields. They may generate heat directly
on the bottom of the cookware. Pots and pans may
cause a variety of noises or vibrations depending on the
way they've been manufactured. These noises are
described as follows:
Low humming (like a transformer)
This noise is produced when cooking at a high heat
level. It is based on the amount of energy transferred
from the cooktop to the cookware. The noise ceases or
quiets down when the heat level is reduced.
Quiet whistling
This noise is produced when the cooking vessel is
empty. It ceases once water or food is placed in the
vessel.
20